Preparing The Cables - Pioneer PDK-TS15U Mode D'emploi

Installing the Product on a TV table etc.
Precautions when installing in a TV table or other enclosure
Do not hold the speaker
Hold the Plasma Display by the handle at
the bottom, with your other hand hold the
top.
When installing in a TV table or
other enclosure, hold the Plasma
Display by the handle at the
Caution
bottom, with your other hand hold
the top. If you hold the speakers,
they may be damaged or twisted.

Preparing the cables

Use the enclosed cable clamps to bind the cables.
Note
Be very careful not to apply force to the bases of the cables.
1
Insert the cable clamps into the cable
clamp mounting holes.
Cable clamps
2
Bundle the cables and place them on each
cable clamp.
3
Close each cable clamp, and then pull its
extremity to make the cables immobile.
Loosening a cable clamp
Cable clamp
mounting holes
Opening a cable clamp
If a cable clamp is closed
too tight, press the
button shown on the left
and push the extremity
of the cable clamp to
loosen it.
Button
Unlock here with a finger.
5
En