Adjustments / Settings / Modes Interface; Startup; Settings; Irrigation Function - ACTEON Equipment Satelec Piezotome 2 Manuel D'utilisation

VII - ADJUSTMENTS /
SETTINGS / MODES /
INTERFACE

7. 1 STARTUP

Important:
After stopping the device, wait four seconds
before restarting it.
By default, when the device is switched on, the
right-hand handpiece is selected.
If no handpiece is connected, the device selects
the right side in P
IEZOTOME

7. 2 SETTINGS

The settings are saved when each program is
configured and are retrieved whenever that
program is selected.

7. 3 IRRIGATION FUNCTION

a) Flush / prime
The flush / prime function is available on the LCD
screen and on the footswitch.
Press button
button (Fig. 8-2) to switch on the flush / prime
function.
The flush / prime function stays on as long as the
button is pressed.
The flush can be switched on while the device is
being used.
mode.
(Fig. 3-1) or the footswitch
b) Flow rate adjustment
The irrigation flow rate is adjusted using buttons
and (Fig. 3-4 and 5).
Each time the corresponding button is pressed,
the flow rate is adjusted. Press and hold buttons
and (Fig. 3-4 and 5) to scroll the flow
rate values.
The adjusted value is displayed on the LCD screen
(Fig. 3-2) and stored in the current program.
The flow rate can be adjusted while the device is
being used.
c) Irrigation ON/OFF
The irrigation is switched ON or OFF by pressing
button (Fig. 3-3) or the footswitch button
(Fig. 8-4).
When irrigation is selected, the symbol
highlighted.
When irrigation is not selected, the symbol
is darkened.

7. 4 LIGHT FUNCTION

The light function is displayed on the LCD screen.
Pressing button
function available for the N
functions ON or OFF.
The light function has a default light-off time-out
of nine seconds.
Switching off the light function becomes
effective when the time-out has elapsed.
If necessary, you can lengthen the time-out (refer
to 7.7).
(Fig. 3-11) switches the light
and P
EWTRON
is
IEZOTOME
11