Urmet H.264 Guide Rapide De Configuration page 30

7. Press "Remote Setting" to configure the cameras on the NVR channels:
Check the firmware version that is currently installed in the NVR, access the menu page [System
8.
version is not recent, the NVR system software (firmware) can be updated by following the instructions described in
paragraph 5.2 of this guide.
The IP cameras in the network can be assigned to the NVR channels automatically by pressing "Auto Assign
9.
Channels" (see screenshot below and paragraph 4.1 for details) or in manual mode (see paragraph 4.2)
The IP cameras detected on the network are thus assigned to the channels and appear in the list:
After having assigned the cameras to the NVR channels, scroll the list of channels all rightwards (see screenshot
10.
below) to check the camera firmware in the last column. If the firmware version is not recent (for Urmet Cloud
cameras the version 01.14.06.4371 or previous is not recent), upgrade the camera firmware as shown in paragraph
5.1.
DS1093-155A 30
Info]. If the