Line Output - Teac UD-501 Mode D'emploi

Settings (2)
Upconverter
Use to activate the upconversion circuit when receiving
PCM format signals.
OFF
Disable the upconverter.
ON
Enable the upconverter.
D/D upconversion to 192 kHz of PCM signals with sam-
pling frequencies of less than 192 kHz is followed by D/A
conversion.
PCM digital filter
Use to set the digital filter when receiving PCM format
signals.
OFF
Disable the digital filter.
SHARP
Use a digital filter with a sharp rolloff.
SLOW
Use a digital filter with a slow rolloff.
o When receiving signals at 352.8 kHz or 384 kHz, the
digital filter will be disabled during playback regardless
of this setting.
16
DSD analog FIR filter
Use to set the analog filter used when receiving DSD for-
mat signals.
FIR1
fc=185 kHz, Gain=−6.6 dB
FIR2
fc=90 kHz, Gain=+0.3 dB
FIR3
fc=85 kHz, Gain=−1.5 dB
FIR4
fc=94 kHz, Gain=−3.3 dB
NOTE
fc: Cutoff frequency
Gain: Filter stage gain

Line output

Use to select the analog audio output connectors used.
RCA
Output through the RCA jacks.
XLR2
Output through the XLR connectors with 2: HOT polarity.
XLR3
Output through the XLR connectors with 3: HOT polarity.