Felco 880/100-100 Manuel D'utilisation page 15

USING THE FELCO 880/100-100 AND/OR
FELCO 880/100-150 EXTENSION POLES
1
1. Make sure that the cable connector is disconnected
from the FELCO 880/100-100 and/or FELCO 880/100-150
extension poles.
2
2. Take the FELCO 880/100-100 and/or FELCO 880/100-150
extension poles, and open the tool attachment system closing
lever (8) (FELCO 801, FELCO 811 or FELCO 820).
Make sure that the two inserts (11) are in good condition and
in place in the tool attachment system 1. If any of the two in-
serts (11) are missing, worn or defective, replace the absent,
worn or defective inserts (11).
3 3
3. Insert the electric pruning shears (FELCO 801, FELCO 811
or FELCO 820) into the tool attachment system (1), making
sure they are correctly positioned.
4
4. Close the tool attachment system (1) around the electric
pruning shears (FELCO 801, FELCO 811 or FELCO 820).
5
5. Close the attachment system by closing lever (8), which
must be fixed to the opposite shell. Lock the attachment system
by locking closely it against the shell. Make sure that the
attachment system closing lever (8) is locked. No part of the
attachment system closing lever (8) must be free to move when
the extension poles are in use.
Check that the electric pruning shears (FELCO 801, FELCO
811 or FELCO 820) are secured in the attachment system (1)
by giving the extension poles a slight pull in the lengthwise
direction.
ENGLISH 15