Festo FDG ZR RF Série Notice D'utilisation page 20

FDG−...−ZR−RF
Fasten the axis fastening kits or centre supports to the FDG−...−ZR−RF as shown
S
in the following diagram:
If necessary, sliding blocks in the profile grooves can serve as fastening devices.
If the FDG−...−ZR−RF is used in conjunction with a drive axis type DGE−... or
DGP(L)−...:
Use the distances between supports of the drive axis also for the FDG−...−ZR−RF.
S
In this way you will avoid distortion due to uneven bending.
Tighten the fastening screws for the transverse fastening at first only slightly
S
(see Fig. 7: Q).
The FDG−...−ZR−RF can then be further adjusted until it is mounted correctly.
Fitting the fastening elements
Make sure that the axis fastening kit or
S
the centre supports are situated outside
the collision range of the slide, by pushing
the slide once over the complete position
ing path.
20
Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó
Fig. 7: Q = Play for transverse fastening
Fig. 8
Festo FDG−...−ZR−RF 0404NH English