Ryobi RMX001 Manuel D'utilisation page 7

This product is for use on a nominal 120 volt circuit and
has a grounding plug similar to the plug illustrated in
Figure 1. Only connect the product to an outlet having the
same configuration as the plug. Do not use an adapter with
this product.
Ground Fault Circuit Interrupter (GFCI) protection should be
provided on the circuit(s) or outlet(s) to be used for the tool.
Outlets are available having built-in GFCI protection and may
be used for this measure of safety.
If the tool is used with an extension cord, ensure the
connection of the tool's power cord and the extension cord
are not on the ground. Auxiliary devices should always be
plugged into the wall outlet and not at the connection of an
extension cord and the power tools' power cord.
If a protected outlet is not available, do not use the tool
until an outlet can be changed or auxiliary protection can
be obtained. These auxiliary protection devices are available
at your local retailer.
POSITION OF THE MIXER
See Figure 2.
To avoid the possibility of the tool plug or outlet getting wet,
position mixer to one side of a wall-mounted outlet to prevent
water from dripping onto the outlet or plug. The operator
should arrange a "drip loop" in the cord connecting the
mixer to the outlet. The "drip loop" is that part of the cord
below the level of the outlet, or the connector if an extension
cord is used, to prevent water traveling along the cord and
coming in contact with the outlet.
If the plug or outlet does get wet, DO NOT unplug the cord.
Disconnect the fuse or circuit breaker that supplies power
to the tool then unplug and examine for the presence of
water in the outlet.
WARNING:
To reduce the risk of electrocution, keep all connections
dry and off the ground. Do not touch the plug with wet
hands.
ELECTRICAL
GROUNDING
PIN
EXTENSION
CORD
7 − English
120 V GROUNDED
OUTLET
DRIP
LOOP
Fig. 1
Fig. 2