Troubleshooting - Ryobi RMX001 Manuel D'utilisation

PROBLEM
Mixer won't start
Mixer stops during operation
Excessive noise or vibration while
drum is spinning
Drum lowers unexpectedly during
operation

TROUBLESHOOTING

POSSIBLE CAUSE
Power supply not connected
On/off switch is in the off position
Motor overloaded and circuit breaker
is tripped
Power supply is disconnected
Motor overloaded and circuit breaker
is tripped
Pivot pin and/or lock handle is not secure Stop the motor and fully insert the pivot
Pivot pin and/or lock handle is not secure Stop the motor and fully insert the pivot
19 − English
SOLUTION
Connect to power supply.
Put on/off switch in on position.
Allow motor to cool, press the circuit
breaker reset button and put on/off switch
in on position.
NOTE: If the mixer still does not start,
unplug the tool and empty some or all of
the batch load. Do not force the mixer.
Reconnect power supply.
Allow motor to cool, press the circuit
breaker reset button and put on/off switch
in on position.
NOTE: If the mixer still does not start,
unplug the tool and empty some or all of
the batch load. Do not force the mixer.
pin and/or lock handle to lock the drum
in place.
pin and/or lock handle to lock the drum
in place.