Maintenance; Lubrication - Ryobi RMX001 Manuel D'utilisation

CLEANING THE DRUM
See Figure 21.
 Unplug the mixer.
 Empty the drum.
 Unlock the drum.
 Lift the handles up to lower the drum opening.
 Using a garden hose, spray clean water into the drum
and rinse away any remaining material
WARNING:
To reduce the risk of electric shock, do not direct water
at or allow water to enter the motor assembly.
 Dispose of concrete, rinse water, and other substances in
areas designated for that purpose. Local, state or federal
laws may prohibit disposal of these materials in storm
drains, roadsides, landfills, or other locations. Consult your
local waste authority for information regarding available
disposal options.
WARNING:
When servicing, use only authorized replacement parts.
Use of any other parts can create a hazard or cause
product damage.
NOTICE:
Periodically, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts,
caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced. Please contact customer service or
a qualified service center for assistance.
OPERATION
 Clean the exterior of the unit using a cloth and warm
water.
NOTE: If necessary, clean the motor assembly with a dry
cloth. Do not allow water to enter the motor assembly.
 Dry the unit completely and store for later use.

MAINTENANCE

GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken, or
destroy plastic which can result in serious personal injury.

LUBRICATION

All of the bearings in this product are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further bearing
lubrication is required.
18 − English
Fig. 21