Tecnolux JC16CA20B Mode D'emploi page 49

5.4.6. Timer setting (1h – 24h)
You can use the timer to turn on or to switch off the appliance.
• Turn off: when power on, press the TIMER button (Fig.5.2); then
press UP/DOWN (Fig.5.4 & 5.6) to select the time.
• Turn on: when power off, press the TIMER button (Fig.5.2); then
press UP/DOWN (Fig.5.4 & 5.6) to select the time.
5.4.7. Swing
Press SWING (Fig.5.1) to turn ON/OFF the swing mode.
5.4.8. Safety
• Automatic defrost: At low room temperatures, frost may build up
at the evaporator during operation. The unit will automatically
start defrosting and the POWER LED blinking. The defrost control
sequence is as follows:
When the unit operates in the cooling operation, drying operation,
the ambient temperature sensor senses the evaporator coil
temperature is below -1°C, after the compressor will stop
operating for 10 minutes or the coil temperature up to 7℃, the unit
restart to cool operating mode.
• Overload protection: In the event of a power loss, to protect the
compressor there is a 3-minute delay until the compressor
restarting.
5.4.9. Drainage
The self-evaporating system uses the collected water to cool the
condenser coils for better efficient performance. It is no need to
empty the drainage tank in cooling operation except in drying
operation and high humidity conditions, see Fig.12. The
condensate water evaporates at the condenser and evacuated
through the exhaust hose.
For continuous operation or unattended operating in drying
operation, please connect the attached drain hose to the unit.
Condensate water can be automatically flow into a bucket or drain
by gravity, see Fig.13.