BASETech 1833947 Notice D'emploi page 44

10.5.4 Deleting ID Cards or User Codes from "OUTPUT 1" (E)
To carry out this programming step the code lock should now be in programming
mode (see Chapter "10.1 Entering Programming Mode").
a) Deleting all ID Cards and User Codes from "OUTPUT 1" (E)
To delete all ID cards and user codes programmed to the relay output "OUTPUT 1" (E) enter the
following key combination:
2 0000 #
b) Deleting User Code or ID Card from "OUTPUT 1" (E)
To delete individual ID cards or user codes programmed to the relay output "OUTPUT 1" (E)
enter the following key combination:
Example delete ID card:
21 Hold the ID card to be deleted up to the "card reader" (5).
Example delete user code:
21 Enter the user code to be deleted.
c) Deleting ID Cards or User Codes using the User Number
To delete ID cards or user codes using the corresponding user number, enter the following key
combination:
22 Enter the user number of the ID card and/or the user code which
is to be deleted.
10.6 Assigning the Activation Method for "OUTPUT 1"
To carry out this programming step the code lock should now be in programming
mode (see Chapter "10.1 Entering Programming Mode").
The relay output 1 "OUTPUT 1" (E) can be activated in three different ways:
1. Activation via ID card
2. Activation via user code
3. Activation via ID card and user code together
44
#
#
#