BASETech 1833947 Notice D'emploi page 43

10.5.2 Programming ID Cards to "OUTPUT 1" (E)
To carry out this programming step the code lock should now be in programming
mode (see Chapter "10.1 Entering Programming Mode").
To programme an ID Card to the relay output "OUTPUT 1" (E) enter the following key
combination:
1 4 digit user number
Example:
1 1112
10.5.3 Programming User Code to "OUTPUT 1" (E)
To carry out this programming step the code lock should now be in programming
mode (see Chapter "10.1 Entering Programming Mode").
To programme a user code to the relay output "OUTPUT 1" (E) enter the following key
combination:
1 4 digit user number
Example:
1 1113
Saving user codes
On the keypad (7) press the key "1" and now enter a 4-digit user number and a 4 to 8-digit user
code. Press the "number" key "#" - the green LED (4) blinks. Press the "number" key "#" again
and the green LED (4) stops blinking. Your entry is confirmed.
If you want to save several codes, you do not have to press the "number" key
"#" again after the second time. Save the individual codes as described above
and press the "number" key "#" after the last entry. This saves all previous
entries as well.
Input:
"1" --- "4-digit user number" --- "4 to 8-digit user code" --- "#" --- "#"
Now hold the ID card up to the "card reader" (5).
The card to be programmed in is held up to the
"card reader" (5)
4-8 digit user code
9876
#
#
#
#
43