uebe cyclotest baby Mode D'emploi page 77

Technical information
Battery:
Service:
Calibration:
Protection class IP:
Expected service
life:
Additional equipment connected to medical electrical equipment
must comply with the respective IEC or ISO standards (e.g. IEC 60950
for data-processing equipment). Furthermore, all configurations shall
comply with the normative requirements for medical systems (see IEC
60601-1-1 or Section 16 of the 3rd edition of IEC 60601-1, respec-
tively). Anybody connecting additional equipment to medical electri-
cal equipment is a system configurer and is therefore responsible for
ensuring that the system complies with the normative requirements
for systems. Attention is drawn to the fact that local laws take priority
over the above-mentioned normative requirements. If in doubt, con-
sult your local specialised dealer or the Technical Service department.
EN-77
RENATA type CR2450N button cell, battery for approx. 500
measurements, battery to be replaced only by UEBE Medical
GmbH. The unit may only be repaired by the manufacturer or by
an expressly authorised organisation. Do not open the unit, as
this will invalidate the warranty.
Should your unit show evidence of a fault, we ask you not to
attempt repairs yourself, but instead to send the unit with a
short description of the fault directly to UEBE Medical GmbH for
inspection, as unit parts cannot be repaired individually.
The unit does not have to be calibrated; the metrological accu-
racy of the unit will be automatically checked when the battery
is replaced by UEBE Medical GmbH.
IP 20: Protected against solid foreign particles with a diameter
of more than 12.5 mm, no protection against water.
5 years