uebe cyclotest baby Mode D'emploi page 52

Operating the unit
Measuring under the arm (axillary) produces inaccurate results. It is
therefore unsuitable for taking accurate measurements.
We recommend that you take the measurement under your tongue
with your mouth closed. Place the sensor tip in one of the two heat
pockets under your tongue to the left or right of the root of the tongue.
The sensor must make good contact with the tissue. Close your mouth
and breathe easily through your nose so that the measurement result
is not compromised by inhaled air.
When the sensor tip is resting steadily and comfortably, press the large
red Measurement button briefly.
Please be patient during the measurement. The sensor must warm up
first (from room temperature to body temperature).
The unit confirms successful measurement (duration of measurement
approx. 60-90 seconds) with a long beep and indicates the measured
temperature in the display at top right. The unit switches off automat-
ically after approx. 1 minute. Your measured value has been automat-
ically stored.
The time of your first measurement remains stored in cyclotest® baby
for all further measurements during a cycle. If, for example, you meas-
ured at 7 o'clock in the morning, you will be reminded of this the next
morning with six short beeps. If you did not hear the first wake-up
sound, you will be reminded after 10 and again after 30 minutes. We
therefore recommend that you choose the time of your first measure-
ment to match your daily rhythm.
cyclotest® baby has a time window of four hours and can store your
measurements even if you measure up to two hours before or two
hours after the time initially established. If you measure outside these
four hours, the measurement is not stored and the following display
appears:
EN-52