Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Bringing into use
Q
Inserting / replacing the batteries
Q
Note: Remove the insulating strips before using the
product for the first time.
Note: Switch the product off before you insert or
remove the batteries.
T urn the battery compartment cover
wise and take it off the battery compartment
(see Fig. A).
I nsert the (new) batteries into the battery
compartment.
Note: Make sure you fit the batteries the right
way round (polarity). The correct polarity is
shown inside the battery compartment.
P ut the battery compartment cover back in
place on the battery compartment and turn it
clockwise to tighten it (see Fig. B).
Installing the light
Q
P ull off the protective film from the self-adhesive
pad
of the battery compartment cover
4
(see Fig. C).
A ttach the light in the desired location.
Note: The substrate should be dry, smooth and
free of dust and grease.
Note: For the first 24 hours after installation do
not remove the self-adhesive pad. Otherwise
the self-adhesive pad will lose its ability to stick.
Switching On / Off
Q
P ress the light in the middle to switch it on or off.
anticlock-
3
Cleaning and care
Q
2
U se a dry cloth to clean the light – never use
petrol, solvents or cleaners that attack plastic.
Disposal
Q
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
3
The packaging is made entirely of
recyclable materials, which you may
dispose of at local recycling facilities.
To help protect the environment, please
dispose of the product properly when it
has reached the end of its useful life and
not in the household waste. Information on
collection points and their opening hours
can be obtained from your local authority.
GB/IE/NI
7
Publicité
Table des Matières
