Setup Settings; Clock Display; On/Off Timer; Control Setting - Sony FWD-32B1 Mode D'emploi

Setup Settings

For the setting method, see the section of "Overview of the Menus" (page 22).
Menu
Language
Timer Setting
Clock Set
Date Set
Time Set

Clock Display

On/Off Timer

ECO Mode
Off/Low/High
Status Display
Speaker Out
Advanced Setup

Control Setting

Index Number
28
GB
Function and operation
Select from the language settings shown. Select "English", "Deutsch", "Français",
"Español", "Italiano" or "
You can adjust time, display the built-in clock, or set the timer to make the display
power on/off at a predetermined time.
Note
If the main power switch is left turned off or the AC power cord removed for a long
time, the built-in clock may lose or gain time significantly.
In this case, reset the clock to the right time.
Sets the day of the week and the hour of the day.
Sets the date (year, month, date). The day is automatically set.
Sets the time.
Select "On" or "Off". If you select "On", when the remote control's DISPLAY
button is pressed, it shows the current time which was set.
Sets the day of the week and the hour of the day.
Note
This cannot be used unless the "Timer Setting" has been set.
Reduces power consumption by changing the brightness of the backlight. Selecting
"High" reduces power consumption more than "Low".
Select "On" or "Off". If you select "On", the input signal and "Aspect" setting
information show on the screen for about 5 seconds when the display is turned on.
When you switch the input signal, the input signal information shows for about 5
seconds.
Tip
You can display the input signal and "Aspect" setting information by pressing
DISPLAY button on the remote control.
Select "On" or "Off". If you select "On", sound is output from the speakers.
Enter more detailed settings.
This menu is used for settings of operation of the display and the remote control.
You can change the index number of the display if necessary. Select to set the index
number of the display with F/f buttons on the display, and press
confirm the setting.
Note
The "Index Number" cannot be set with the remote control.
".
button to