Troubleshooting Chart - Sharp RP-20 Mode D'emploi

Troubleshooting chart

If something is wrong with this product, check the following
before calling your authorized SHARP dealer or service
center.
■ General
Symptom
● Unable to power ● AC power cord is not plugged
on.
● Sound is noisy or ● The unit is too close to a TV
distorted.
● Speakers are too close to the
● Worn out or dirty stylus. Clean
● Vinyl record is dirty or dusty.
● Tonearm skips, ● Vinyl record is dusty or
skates, or does
not move across
the vinyl record.
● The surface is not level. Place
● Incorrect tempo. ● Incorrect speed control
■ USB
Symptom
● Device cannot be ● There is no MP3 file inside
detected.
● The device is not properly
● Playback does not
start.
● An MTP device is connected.
● The device contains AAC
● A false MP3 file is being
● REC ERR appears ● The USB device is not
● The USB device is removed
Possible cause
in to the AC outlet.
set or another similar appli-
ance.
vinyl record player. Move the
speakers away from the vinyl
record player.
or replace the worn stylus.
scratched. Clean or replace
the vinyl record.
the vinyl record player on a
flat, level surface.
chosen. Set the rpm to match
the one indicated on the vinyl
record.
Possible cause
the device.
connected.
files only.
played back.
inserted properly into the USB
terminal.
during recording.
■ Condensation
Sudden temperature changes, storage or operation in an
extremely humid environment may cause condensation
inside the cabinet. Condensation can cause the unit to
malfunction. If this happens, leave the power on until
normal playback is possible (about 1 hour). Wipe off any
condensation on the unit with a soft cloth before operating
it.
■ If problem occurs
When this product is subject to strong external interference
(mechanical shock, excessive static electricity, abnormal
supply voltage due to lightning, etc.) or if it is operated
incorrectly, it may malfunction.
If such a problem occurs, do the following:
1
Turn the power off, and then turn it on again.
2
If the unit is not restored in the previous operation,
unplug and plug in the unit again, and then turn the
power on.
■ Before transporting the unit
● Remove all devices connected to the unit. Then, turn
the power off and unplug the AC power cord. Carrying
the unit with other devices left connected might
damage the unit.
● Remove the vinyl record as this might damage the
vinyl record and/or unit.
● Put the stylus guard back to protect the stylus.
● Place the tonearm back to the tonearm rest and lock it
with the security hook.
● Turn the transportation screw anti clockwise to the
maximum.
E-12