Joie i-Spin Safe Mode D'emploi page 7

!
After attaching the ISOFIX, pull the
load leg downward to floor. When
the load leg indicator shows green,
the load leg is installed correctly.
!
Squeeze the load leg releasing
button, then adjust the load leg
length. 7
!
The load leg has multiple positions.
When the load leg indicator shows
red this means the load leg is in the
wrong position.
8
!
Make sure the load leg is in full
contact with the vehicle floor pan.
Red means it is installed
incorrectly.
8
!
Check to make sure the base is
securely installed by pulling on
both ISOFIX connectors.
!
The ISOFIX connectors must be
attached and locked onto the
ISOFIX anchor points.
9
!
The load leg must be installed
correctly with green indicator.
11
7
8
9
-1
-2
9
1
Removing the base
To remove from the vehicle press
the ISOFIX adjuster button
pull the base back from the seat.
-2
10
Then press and release the
connectors from the vehicle's
ISOFIX.
11
To prevent damage during transit,
press the ISOFIX adjuster button
12 -1 and fold the connector
2
completely. -2
12
10
-1 and
10
2
11
2
12
2
1
1
1
12