Troubleshooting - Scheppach 5906501901 Traduction Du Manuel D'origine

GB

14. Troubleshooting

Fault Possible cause
E1 Coil Sensor-Error
E2 Moisture Sensor-Error
E3 Temperature Sensor-Error
E4 Hot and Cold System-Error
E5 Room Temperature too high
ERROR
Dehumidifier does not work.
Bad Dehumidification Perfor-
mance
High Noise Level
Water flows out of the device
22 І 76 22 І 76 22 І 76
Remedy
Exchange the coil sensor.
Exchange the moisture sensor.
Exchange the temperature sensor.
Have the dehumidifier checked /repaired by a specialist.
Lower the room temperature and
dehumidifier will restart automatically.
ERROR
• Device has no power.
• Mains plug is not plugged in prop-
erly.
• Display shows error code FU.
• Air in- or outlet is covered.
• Room is not closed.
• Low moisture and temperature.
• Device was not put on even ground.
• Air in- or outlet is covered.
Leakage of the water collecting con-
tainer.
SOLUTION
• Turn on the power supply.
• Connect the mains plug properly.
•
• Empty the water collection container.
• Uncover Air in- and outlet.
• Close all doors and windows.
• The lower the room temperature the
worse the dehumidification perfor-
mance.
• Position the device on even ground.
• Uncover Air in- and outlet..
• Check the water collecting container.
• Replace the water collecting con-
tainer.