Install And Attach Exterior; Train Your Pet - Petsafe Pet Door PPA11-10915 Manuel D'installation

Step 6

Install and Attach Exterior

6A. You are now ready to work from the outside wall. With
B side in position, mark location of 4 toggle bolt holes.
Remove B side of the pet door.
6B. Drill marked locations with ½" (13 mm) drill bit.
6C. Install the toggle bolts into the B side. Slide the B side
of the Pet Door into the A side that is already installed
on the inside. The unit will slide together just like it was
in the package.
Fit
Inspect the unit for a snug fit and any gaps that
Check
could cause a draft or water penetration. Either tighten the fit
or use closed cell foam and/or silicone caulk in these areas.
Helpful Tip: If installing in a vinyl siding application, you may
want to place closed cell foam and/or silicone caulk between
the pet door flange and the siding.
Step 7

Train Your Pet

7A. Bring your pet to the pet door. Temporarily tape both flaps up
and try to talk your pet into going through. If your pet will not go
through the door do not force him through the door, simply wait
for your pet to go through on his own.
Helpful Tip: Sometimes it helps for you to be on one side of the
door and your pet on the other. You may try persuading your pet
through the door using a small piece of food or a treat.
www.petsafe.net
6A
6B
6C
7A
9