Restarting; Changing Cycles And Options; Status Lights; Cycles - Whirlpool WFC7500 Guide D'utilisation Et D'entretien

Restarting

To restart the washer at any time, select CANCEL/DRAIN.

Changing Cycles and Options

Not all Options are available with all Cycles.
Cycles and Options can be changed anytime before START is
selected.
To stop a cycle and select a new cycle
1. Press and hold CANCEL/DRAIN for 3 seconds.
2. Select desired cycle.
3. Select the desired OPTIONS.
4. Select and hold START (for approximately 3 seconds) to
restart the washer at the beginning of the new cycle.
To cancel a cycle and to drain the washer manually
1. Press and hold CANCEL/DRAIN for 3 seconds.
2. The pump will turn on to drain out the water and the door will
unlock.
NOTE: It will take approximately 1 minute for the door to
unlock.
3. The washer cycle stops, the door unlocks and clothes can be
removed.
4. To power down the washer manually after the wash cycle is
complete, switch knob to Off position.
NOTE: If the water level is too high, the washer will drain
automatically before the door unlocks.

Status Lights

These lights show which portion of the cycle the washer is
operating.
Sensing
The washer automatically weighs items then adjusts the
Estimated Time Remaining, based on the cycle selected.
Cycle Complete
The Cycle Complete status light stays on for 1 hour after the
cycle is complete. To power down the washer manually after the
wash cycle is complete, switch knob to Off position.
Estimated Time Remaining
The cycle times vary automatically based on your water pressure,
water temperature, detergent, and clothes load. The cycle time
will be extended if oversudsing occurs or the load is unbalanced.
The oversuds routine removes extra suds and assures proper
rinsing of your garments. The options you select will also affect
the cycle times that are shown in the Preset Cycle Settings table.
The Estimated Time Remaining can change to much longer times
under extreme conditions.
14
Door Locked
When the Door Locked LED light illuminates, the door is locked.
The door is locked and unlocked automatically, depending on the
stage of the wash cycle. Press and hold CANCEL/DRAIN for
3 seconds to unlock the door manually. It will take approximately
1 minute for the door to unlock.
Wash Cycles
Choose Wash Cycles by rotating the Cycle selector knob to the
desired cycle. The indicator light for the cycle selected will
illuminate. Each cycle is designed for different types of fabric and
soil levels.
Each cycle has a default cycle time, WASH TEMP, and may
have preset Options. The preset settings provide the
recommended fabric care for the selected cycle.
The preset settings can be changed anytime before START is
selected. Not all Options and Modifiers (WASH TEMP, spin
options) are available with all Cycles. Select and hold START
(for approximately 3 seconds) to continue the cycle.
Preset Cycle Settings
Each cycle has a preset Cycle Time and WASH/RINSE TEMP.
The preset settings provide the recommended fabric care for the
selected cycle. See chart.
Cycle
Estimated
Time*
(hr:min)
Normal 0:50
Quick Wash 0:30
(2-3 items)
Delicate 0:37
Clean Washer 1:15
Drain/Spin 0:18
Rinse/Spin 0:24
Heavy Duty 1:10
Casual 0:45
*The cycle times vary automatically based on your water
pressure, water temperature, detergent, and clothes load. The
cycle time will be extended if oversudsing occurs or the load is
unbalanced.

Cycles

Wash Temp Spin Speed
Warm High
Warm High
Warm Low
Hot High
N/A High
Cold High
Warm High
Warm Low