WINK Relay Guide De L'utilisateur page 25

6 Push all wires back into wall as far as possible.
7 Screw power box in place with the two (2) screws provided.
8 Turn power back on at circuit breaker.
9 On the front of the power box, you will see two buttons
and an LED light.
If wired correctly, the LED light will be solid green.
Press the button the load (light) was wired to: the light
should turn on.
If the LED light does not light up green,
see Troubleshooting section.
LOAD 1
LED LIGHT
LOAD 2
(NOT IN USE)
25