WINK Relay Guide De L'utilisateur page 21

6 Push all wires back into wall as far as possible.
7 Screw power box in place with the two (2) screws provided.
8 Turn power back on at circuit breaker.
9 On the front of the power box, you will see two buttons
and an LED light.
If wired correctly, the LED light will be solid green.
Press the top button: the first load (light) attached to
load 1 (step 7) should turn on. Press the bottom button:
the load (light) attached to load 2 (step 8) should turn on.
If the LED light does not light up green,
see Troubleshooting section.
LOAD 1
LED LIGHT
LOAD 2
21