WINK Relay Guide De L'utilisateur page 24

4 Connect wires from wall to wires in power box as follows:
NOTE: Colors of wires may vary depending on your gang box.
Consult a qualified electrician if you are unsure about a wire.
Connect the hot wire from the gang box (usually black)
to the red 2-pole connector on the power box.
Connect the neutral wire(s) from the gang box (usually
white) to the white 4-pole connector on the power box.
Connect one of the load wires from the gang box
(usually black) to one of the black 2-pole connectors
on the power box.
5 There are no bare copper (ground) wires on the power box,
however there will be ground wires in your wall; connect
them all using the green 4-pole wire connector (included).
NOTE: Your ground wires may already be attached together
with a connector. If this is the case, you will not need to
complete this step. WARNING: Cap any loose wires.
24
3
1
2