BH FITNESS G233N Instructions De Montage Et Utilisation page 12

Connect the top part of the manual
pulse rate cable (26) and the central
part (25). Push any excess cable back
down into the main post (7), slide the
monitor (11) onto the plate on the main
post (7) and screw it into position.
Figure 6
A) Slide the top right-hand handlebar
(12) onto the
handlebar (8) using the flat washers
(22) and bolts (21) to secure it.
B) Slide the top left-hand handlebar
(13) onto the
handlebar (9) using the flat washers
(22) and bolts (21) to secure it.
C) Remove screws (B) (23) located on
the main post (7) and fi i t the bottle
holder using the same screws (23).
Figure 7
LEVELLING
Once the appliance has been placed
into its fi nal position, make sure that it
right-hand central
left-hand central
is level on the floor. This can be
achieved by screwing the adjustable
blocks (33) on the rear stabiliser bar
(3) either in or out, as shown in Fig. 7.
Figure 8
REPOSITIONING
wheels (32) located at the front to make
it easier to move the appliance about,
see Fig. 8.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
12
There are two