Burning Coal; Low.heating.(For.devices.suitable.for.continuous.use) - Dovre Astro 3MF Installation Et Mode D'emploi

Low intensity fires cause tar
and. creosote. to. deposit. in.
the.chimney.after.a.long.pe-
riod. of. time..Tar. and. creo-
sote.are.highly.combustible.
substances.. Thicker. layers.
of. these. substances. might.
catch fire when the tempe-
rature.in.the.chimney.incre-
ases. suddenly. and. steeply..
Therefore.it.is.necessary.for.
the fire to regularly burn very intensely, so that thin layers of tar and creosote immediately
disappear.
Low intensity fires also cause tar to deposit on the stove panels and doors.
When.it.is.not.too.cold.outside.it.is.better.to.let.the.stove.burn.intensely.for.just.a.few.hours.
a.day.

Burning coal

FOR.BURNING.WITH.COAL,.THE.AIR.INTAKE.ABOVE.THE.DOOR.(2).(=.SECON-
DARY.AIR.INTAKE).MUST.BE.CLOSED.AT.ALL.TIMES....
When the ignition fire has sufficiently stabilized and when there is a sufficient blaze, then a
scoop of coal can be added to the fire.
Use the front door when filling. Once the coals have ignited, the addition of coals can be
completed. Make sure that you do not put out the fire by adding too much coal at once. After
the.coals.have.been.burning.well.for.some.time,.adjust.the.level.of.the.primary.air-inlet..Just.
prior to refilling, open the primary air-inlet completely. Now use the shaking grate and shake
until.glowing.bits.fall.into.the.ash.drawer..After.that,.add.coal....
After.a.couple.of.minutes,.adjust.the.primary.air-inlet.to.the.desired.position..Add.a.maxi-
mum amount of coal until you can just make out the glow of the previous filling.
When the fire basket or the cast-iron plate fins are red-hot, you are heating too intensely.
Low heating (for devices suitable for continuous use)
To use the advice as a "continuous fire", you can select the primary ans secondary air scoops
in.such.a.way.you.get.the.right.burning.speed..Always.make.sure.there's.enough.glow.on.the.
heating.bottom.
34.