Centering The Running Belt - Vision Fitness T80 Manuel Du Propriétaire

TENSIONING THE RUNNING BELT
For more information and/or how-to videos, visit our Customer Support section on our
website. Contact information is located on the back panel.
CAUTION
Running belt should NOT be moving during tensioning. Over-tightening
the running belt can cause excessive wear on the treadmill as well as its
components. Never over-tighten the belt.
If you can feel a slipping sensation when running on the treadmill, the running belt
must be tightened. In most cases, the belt has stretched from use, causing the belt
to slip. This is a normal and common adjustment. To eliminate this slipping, turn
the treadmill off and tension both the rear roller bolts using the supplied Allen
wrench, turning them ¼ turn to the right (clockwise) as shown. Turn the treadmill on
and check for slipping. Repeat if necessary, but never turn the roller bolts more than
¼ turn at a time. Belt is properly tensioned when the slipping sensation is gone.
12
VF_12_T80_OM_rev1_9.indd 12-13

CENTERING THE RUNNING BELT

For more information and/or how-to videos, visit our Customer Support section on our
website. Contact information is located on the back page of the OWNER'S MANUAL.
CAUTION
Do not run belt faster than 3 mph/4 kmh while centering. Keep fingers, hair
and clothing away from belt at all times.
If the running belt is too far to the right side: Using the supplied Allen wrench
TIGHTENS RIGHT SIDE OF ROLLER
and with the treadmill running at 3 mph/4 kmh turn the LEFT adjustment bolt counter-
clockwise a ¼ turn and wait for the belt to adjust itself. Repeat if necessary, until the
belt remains centered during use.
If the running belt is too far to the left side: Using the supplied Allen wrench and
with the treadmill running at 3 mph/4 kmh turn the LEFT adjustment bolt clockwise a
¼ turn and wait for the belt to adjust itself. Repeat if necessary, until the belt remains
centered during use.
• If you find the belt is slipping because it is too loose, center it then tension as
needed.
• For easier adjustment bolt access, remove the end caps.
TIGHTENS LEFT SIDE OF ROLLER
BELT IS TOO FAR TO THE RIGHT SIDE
BELT IS TOO FAR TO THE LEFT SIDE
13
12/12/12 2:35 PM