Important - Vision Fitness T80 Manuel Du Propriétaire

ASSEMBLY STEP 5
HARDWARE FOR STEP 5:
FLAT
SPRING
BOLT (I)
WASHER (H)
WASHER (J)
45 mm
8.4 mm
8.2 mm
Qty: 4 Qty: 2
Qty: 2
BOLT (I)
FLAT WASHERS (H)
CONSOLE REAR COVER
PRE-INSTALLED
SCREWS
CONSOLE CABLES
FLAT WASHERS (H)
SPRING WASHER (J)
NUT (K)
28
VF_12_T80_OM_rev1_9.indd 28-29
Open HARDWARE FOR STEP 5.
A
Remove 2 PRE-INSTALLED SCREWS to
B
remove CONSOLE REAR COVER from the
NUT (K)
Qty: 2
CONSOLE.
Attach the CONSOLE to the CONSOLE BASE
C
using 2 BOLTS (I) and 2 FLAT WASHERS (H)
from above and 2 FLAT WASHERS (H)
2 SPRING WASHERS (J) and 2 NUTS (K)
from below.
CONSOLE
CONSOLE BASE
NOTE: Be careful not to pinch the console
cables while attaching the console.
Connect the CONSOLE CABLES to the
D
CONSOLE.
Re-attach the CONSOLE REAR COVER to
E
the CONSOLE using 2 PRE-INSTALLED
SCREWS.
ASSEMBLY STEP 6
HARDWARE FOR STEP 6:
BOLT (L) BOLT (M)
20 mm 20 mm
Qty: 4 Qty: 6
CONSOLE BASE HANDLEBAR
CONSOLE BASE COVER WATER BOTTLE HOLDER
BOLTS (L) BOLTS (M)
Open HARDWARE FOR STEP 6.
A
Attach the CONSOLE BASE COVER to the
B
CONSOLE BASE using 4 BOLTS (L).
Attach WATER BOTTLE HOLDER and
C
ACCESSORY HOLDER to left and right
HANDLEBARS using 6 BOLTS (M).

IMPORTANT

This treadmill has a pre-waxed belt and
should never be lubricated. Waxing
the belt can cause damage that is not
covered by the warranty.
ASSEMBLY COMPLETE!
12/12/12 2:36 PM
29