Charging Your Phone; Inserting A Micro Sd Card - LG P930 Guide De L'utilisateur

Charging your phone

1
Connect the cabless wall adapter and USB
cable as shown below. The LG logo on the
USB cable should face toward you.
2
Plug the USB cable (as shown below) into
the phone's charger/accessory port. Make
sure the 'B' side is facing upwards.
NOTE
The battery must be fully charged
initially to improve battery lifetime.
NOTE
Your phone has an internal antenna.
Be careful not to scratch or damage
this rear area, as that will cause loss
of performance.
If the phone is turned off as the battery
is fully discharged, the battery is called
a weak battery. In this case when the
phone connect to the charger(TA or
USB) cable, the keypad LED at the
bottom of the phone will be blinking.
This is normal operation in the weak
battery to prevent over-current flowing
because the phone is designed
to provide reasonable protection
algorithm for against damage of
battery. And after a few minutes, the
LCD is turned on normally.

Inserting a micro SD card

Insert a micro SD™ card to use the
camera and other multimedia features.
Multimedia contents can be saved in the
micro SD card. LG-P930 has a micro SD
card pre-installed.
37 37