Prepare The Scanner For Use; Test The Installation - Hewlett Packard Scanjet Enterprise 9000 Guide De Démarrage Rapide

Prepare the scanner for use

1. Attach the output tray by sliding the back of the tray into the slot under the front of the
scanner.
Ensure that the output tray does not extend beyond the surface on which the scanner
sits.
2. Extend the document feeder.
3. Extend the output tray by sliding out the paper guide and lifting the flap.

Test the installation

CAUTION: Before placing an item in the document feeder, make sure that the item
does not contain wet glue, correction fluid, or other substances that can be transferred
to the interior of the scanner.
Make sure there are no curls, wrinkles, staples, paper clips, or any other attached
material. Sheets should not be stuck together.
To test a standard installation, follow these steps.
1. Place a single page face down in the document feeder.
TIP: Place A3 (or Tabloid 11 x 17 in) pages with the short edge down, as shown.
You can place A4 (or Letter 8.5 x 11 in) and smaller pages with either the long
edge (landscape) or short edge (portrait) down.
2
1
3
Test the installation 5