Connecting To The Mains - Bosch UniversalGardenTidy Notice Originale

Souffleur de feuilles/aspirateur de jardin
Masquer les pouces Voir aussi pour UniversalGardenTidy:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
14 | English
Do not over reach and keep your bal-
u
ance at all times.
Always be sure of your footing on
u
slopes.
Walk, never run.
u
Keep all cooling air inlets clear of
u
debris.
Never blow debris in the direction of
u
bystanders.
Do not carry the product by the
u
cable.
The wearing of a face mask is recom-
u
mended.
Wait until all product components
u
have completely stopped before
touching them. The fan continues to
rotate after the product is switched
off and can cause injury. Disconnect
supply cord from mains.
Do not modify the product. Unau-
u
thorized modifications may impair
the safety of your product and may
result in increased noise and vibra-
tion.
When in vacuum mode, objects
u
other than leaves and garden waste,
as stipulated in the Intended Use,
could be collected.
Do not vacuum solid objects such as
big branches, broken glass, pieces of
metal and stones.
A worn fan or blower housing (chips,
u
cracks, nicks) may cause an in-
creased risk of injury from thrown
foreign objects. If the fan or blower
housing are damaged, consult the
Bosch hotline.
F 016 L81 834 | (21.03.2019)
In rare cases (e.g. prolonged use in
u
hot, dry conditions) a blower va-
cuum can generate an electrostatic
charge, that may be felt on contact
with the product.
Remove the plug from the socket:
– Whenever you leave the product
– Before checking, clearing a block-
age or working on the product
– After a collision with a foreign ob-
ject. Inspect the product for dam-
age and make repairs as necessary
– If the product starts to vibrate ab-
normally (check immediately)

Connecting to the mains

The voltage of the power source
u
must correspond with the data on
the type plate of the product.
We recommend that this product is
u
only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA resid-
ual current.
Only use or replace power supply
u
cables for this product which corres-
pond to the types indicated by the
manufacturer. Contact the Service
Centre to do this.
Never touch the mains plug with wet
u
hands.
Do not run over, crush or pull the
u
power supply cord or extension
cord, otherwise it may be damaged.
Protect the cable from heat, oil and
sharp edges.
Bosch Power Tools

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

3 600 hb1 0 série

Table des Matières