Ansmann Energy POWERLINE 4 TRAVELLER Manuel D'utilisation page 6

GB
OPERATING INSTRUCTIONS POWERLINE 4 TRAVELLER
Fast charger with discharge option for 1-4 nickel-cadmium (NiCd) or nickel-metal-
hydride (NiMH) rechargeable batteries with sizes of Micro (AAA) or Mignon
(AA).
FEATURES
Plug-in charger with wide-range input for worldwide use; Individual charging
circuit for each battery; Continuous battery testing in order to detect short-circuit
or high resistant batteries; Automatic start of charging at contact with the battery;
NiCd as well as NiMH batteries can be charged at the same time; The battery's
charge status before start of charging is not important; A microprocessor monitors
each rechargeable battery's voltage during the whole charging period; Constant
supervision of voltage levels and termination of fast charge by –delta V method
and safety timer; Automatic switch-over to trickle charging; Charging times
depend on capacity of the cells; Optional discharging by push button; after that
automatic switch-over to charging mode; Status display via LEDs
DISPLAY
LED red (1): This LED indicates that fast charging of at least 1 of the cells is
in operation.
LED green (2): There are a total of 4 green LEDs, each one is allocated to
a charging slot. If one of these green LEDs flashes slowly (1x per second), the
battery associated to it is being fast charged. If a green LED lights continuously,
that battery has been fully charged and is now provided with trickle charge in
order to keep it topped up without losing capacity. If a green LED flashes quickly
(4x per second), the charger has detected a battery defect; the charging current in
this chamber is switched off. A distinctive feature of these 4 LEDs is the moving bar
effect display from the right to the left, which indicates the discharging process
for all batteries.
Discharge button (3): Press this button (PRESS) for approx. 2 seconds to start
the discharging process of the rechargeable cells.
ATTENTION!