Call Waiting; Setting The Flash Time - TIPTEL 114 Mode D'emploi

Call Waiting

Please note: To use this feature you must subscribe to a Call Waiting service
from your network provider.
When you are on a call and another caller is trying to get through, the Call Waiting
beep will sound to alert you.
1. Press (R) to put your current call on hold and accept the waiting call.
2. Press (R) again to alternate between the two calls.

Setting the flash time

You can set the flash time at 100 or 300 ms.
Slide the flash switch on the handset to the desired setting.
Please, ask your network provider or PBX installer (in case this device is used behind
a PABX) for the appropriate setting
Using the phone
24