Operation; Symbols And Their Meaning; Symbol Explanation - Bosch Purion BUI215 Notice D'utilisation D'origine

Symbols and their meaning

Symbol Explanation
Short button press
(less than 1 second)
Medium button press
(between 1 second and 2.5 seconds)
Long button press
(longer than 2.5 seconds)
Start-up
Requirements
The eBike system can only be activated when the fol-
lowing requirements are met:
– A sufficiently charged battery is inserted (see bat-
tery operating instructions).
– The speed sensor is connected properly (see drive
unit operating instructions).
Switching the eBike system on/off
The following options are available for switching on
the eBike system:
– Press the on/off button (1) of the on-board com-
puter with the eBike battery inserted.
– Press the on/off button of the eBike battery (see
battery operating instructions).
The drive is activated as soon as you start pedaling
(except for in the push assistance function or with the
assistance level OFF). The motor output depends on
which assistance level is set on the on-board com-
puter.
As soon as you stop pedaling when in normal opera-
tion, or as soon as you have reached a speed of
20/28 mph, the eBike drive unit switches off the as-
sistance. The drive is automatically re-activated as
soon you start pedaling again and the speed is below
20/28 mph.
The following options are available for switching off
the eBike system:
Bosch eBike Systems

Operation

– Press the on/off button (1) of the on-board com-
puter.
– Switch off the eBike battery using its on/off button
(some bicycle manufacturer-specific solutions pre-
vent access to the battery on/off button; see the bi-
cycle manufacturer operating instructions).
The system shuts down after being switched off. This
takes approximately three seconds. It cannot be
switched back on until shutdown has been com-
pleted.
If the eBike is not moved for approx. ten minutes and
no button is pressed on the on-board computer, the
eBike system switches off automatically in order to
save energy.
Note: Always switch off the eBike system when you
park the eBike.
Note: If the batteries of the on-board computer are
drained, you can still switch on your eBike using the
bike's battery. It is, however, recommended that you
replace the internal batteries as soon as possible in
order to avoid damage.
Energy supply of the on-board computer
The on-board computer is supplied with voltage by
two CR2016 button cells.
English – 7
1 270 U20 XBP | (08.04.2020)