Using Your Blender - Hamilton Beach Professional B79 Manuel D'utilisation

Using Your Blender

Before first use: After unpacking the Blender, follow the instructions in "Care and Cleaning."
IMPORTANT: The Blender Jar and Cutting Blade Assembly are subject to wear during normal
use. Always inspect Jar for nicks, chips, or cracks. Always inspect Cutting Blade Assembly for
broken, cracked, or loose blades. If Jar or Cutting Blade Assembly is damaged, do not use.
1.
Place Blender Jar on base.
3.
Place Lid on Jar. Insert the Emulsion
Cup into the Lid and secure by turning
clockwise. Remove cup to use the
Tamper or to add ingredients.
8
2.
Add ingredients.
4.
Remove Emulsion Cup; rotate
counterclockwise from "locked" to
"unlocked" position and lift out. Insert
Tamper into hole in Lid.
NOTE: Turn Blender OFF ( ) before
removing Emulsion Cup and when
adding the Tamper.
5.
Plug in Blender. Move the RESET/OFF (I/
) Switch to the RESET (I) position to
turn on power to the Blender and ready
it for blending. The front lights will come
on. Move the RESET/OFF (I/ ) Switch to
the OFF ( ) position and remove plug
from socket anytime the machine is left
unattended. If Blender is plugged in and
Switch is in ON (I) position, but panel
lights are not illuminated, the Blender has
entered standby mode. This will happen
after 3 minutes of inactivity. Press any
control panel button to resume normal
operation.