Environmental Protection; Declaration Of Conformity - stayer LEN751E Instructions D'emploi

Removal rate and
determined by the speed and grade of the
sanding belt. The higher the belt speed, the more
material is removed and the finer the sanded
surface.
Work using the least possible sanding pressure;
the machine's own weight is sufficient for a good
sanding performance. This gives longer life to the
sanding belt, makes the workpiece surface
smoother and reduces the energy consumption .
Apply the machine to the workpiece only when
switched on. Work with moderate feed and carry
out the sanding with parallel and overlapping
strokes. Sand in the direction of the grain; sanding
across the grain produces an uneven sanding
effect.
The auxiliary handle can be unscrewed if it
should restrict the sanding area.
Particularly when sanding coats of varnish, it is
possible that these melt and smear the surface
of the workpiece and the sanding belt. Therefore
sanding dust must be extracted as described
under
"Dust Extraction".
Worn, clogged or
damage the workpiece
should therefore be changed in good time.
• Before any work on the machine itself, pull
the mains plug.
• For safe and proper working, always keep the
machine and the ventilation slots clean.
Remove any clogged sanding dust with a
paintbrush.
From time to time remove the protective
and clean the dust passage so that the suction
performance remains at an optimum leveL.
If the machine should fail despite the care taken
in manufacturing and testing procedures , repair
should be carried out by an after-sales service
centre for STAYER power tools.
surface quality
torn sanding belts can
. The sanding belts
ENGLISH
9
are
Measured values determined according to
EN 60745
LEN 610, LEN 690:
Typically the A-weighted noise levels of the product
are: sound pressure level: 93.5 dB (A); sound
power level: 106.5 dB (A).
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s
LEN 751:
Typically the A-weighted sound pressure level of
the product is 93.5 dB (A).
The noise level when working can exceed
106.5 dB (A).
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s

Environmental Protection

Recycle raw materials instead of disposing as
waste
The machine, accessories and pack aging should
be sorted for environmental-friendly recycling .
These instructions are printed on recycled paper
manufactured without chlorine .
The plastic components are labelled for
categorized
recycling .

Declaration of Conformity

We declare under sole responsability that this product
is in coformity with the following standards or
standardisation documents: EN60745, according to
the provisions of the directives 2006/42/CE,
2004/108/CE, 2006/95/CE
cap
April 5, 2016
9
.
2
.
2
Ramiro de la Fuente
Director Manager