BaSt-ING Schleiferl Notice D'utilisation page 21

(6)
Grinding shaft
(7)
Sanding belt
(8) Wing nut
cover hood
(9) Wing nut
grinding belt guide
(10)
Exchange shaft
(11)
Drive shaft
(12)
Wing nut
exchange shaft
(13)
Wing nut
sliding plate
(14)
Cover
(15)
Angle display
The grinding shaft engages in the tooth. A suitable grinding shaft
must be used depending on the chain pitch.
The sanding belt carries out the sanding process. Use only
approved abrasive belts. The original abrasive belts are optimized
for chain sharpening and achieve correspondingly good
sharpening results.
The cover hood can be removed with this wing nut.
This is necessary to change the sanding belt.
With item 9 the belt run of the sanding belt is corrected/set.
At this point in the grinder, the grinding shaft is kept for further
chain divisions.
The grinder is driven by a 6.3 mm hexagon (1/4" bit holder).
The grinder must be positively connected to the drive shaft with
a suitable drive device. This must be set clockwise.
The replacement shaft is fixed to the grinder with this nut.
This wing nut is loose during regular operation. When changing
the sanding belt, the sliding plate is pushed forward and locked
with the wing nut (13). This means that the sanding belt can be
easily changed.
This cover protects you from unintentionally reaching into the
sanding belt. Only remove this to change the sanding belt.
The angle displays provide orientation when sharpening the
teeth. For a correct and even sanding, these should be
held/positioned parallel to the saw bar when sharpening.
With the supplied gauge, these can be set to the desired angle.
– 21 –