Connecting A Vacuum Cleaner - Makita PC5010C Manuel D'instruction

1
3
4
5
► 1. Lock nut 2. Convex section 3. Offset diamond
wheel 4. Inner flange 5. Spindle 6. Shaft lock

Connecting a vacuum cleaner

Optional accessory
When you wish to perform clean concrete-planing
operation, connect a Makita vacuum cleaner to your
tool. Then connect a hose of the vacuum cleaner to the
nozzle as shown in the figures.
Installing or removing dust cover
attachment
Optional accessory
WARNING:
Always be sure that the tool is
switched off and unplugged before installing or
removing the dust cover attachment. Failure to do
so causes damage to the tool or a personal injury.
There are four pieces of dust cover attachment and
each is used in one of different positions.
2
1
► 1. Marking A 2. Marking B 3. Marking C
4. Marking D
Set the dust cover attachment so that the marking (A,
6
B, C or D) places as shown in the figure. Snap its pins
in the vents.
Dust cover attachment can be removed by hand.
NOTE: Clean out the dust cover attachment when it
is clogged with dust or foreign matters. Continuing
operation with a clogged dust cover attachment will
damage the tool.
OPERATION
Concrete planing operation
CAUTION:
one hand on the housing and the other on the
auxiliary handle as shown in the figure.
CAUTION:
a vacuum cleaner is connected to the tool and
turned on.
CAUTION:
brush. Use of damaged brush could lead to injury by
leaking dust.
Always install the auxiliary handle on the tool before
operation. Hold the tool's switch handle and the auxil-
iary handle firmly with both hands during operation.
9 ENGLISH
3
ALWAYS hold the tool firmly with
Before operation, make sure that
Do not use the tool with damaged
4
2