Care And Maintenance - Danby Designer DPA100D1MDD Guide D'utilisation Et Soins De Propriètaire

CLEANING
• Unplug before cleaning.
• Wipe with soft semi-dry cloth. DO NOT use chemical agents, such as benzene, alcohol, gasoline, etc. Otherwise the
surface of the A/C and, potentially, the whole A/C will be damaged.
• Prevent water from spilling into the A/C.
FILTER
• Wash the fi lter once every two weeks. It may be necessary to wash it more often if air quality is poor. If it is blocked by
dust, the effi ciency of the A/C will be reduced.
• Pull out the air inlet grille and the fi lter as shown in the picture below.
• Wash the air inlet grille and the fi lter in warm water (about 40°C / 104°F) with neutral detergent added. Allow to dry in
a shaded area after cleaning.
SEASONAL CLEANING
If the A/C will not be used for a long time:
• Drain the internal container as outlined in the Drainage Method section.
• Run the A/C under fan mode for 2 hours until the inside is dry.
• Turn the A/C off and unplug it.
• Wash and dry the air inlet grille and the fi lter and reassemble them.
• Remove the exhaust pipe.
• Cover the A/C and exhaust pipe with a plastic bag and store them in a dry place.
DISPOSAL
Check for local regulatory compliance regarding the approved and safe disposal of this appliance.

CARE AND MAINTENANCE

NOTICE
In order to avoid electric shock, please turn off the A/C and
unplug the plug before maintenance or repair.
9