Care And Maintenance - Danby Designer DPA100D1MDD Guide D'utilisation Et Soins De Propriètaire

Notice: in order to avoid electric shock, please turn off the A/C and unplug the plug before maintenance or repair.
CLEANING
• Unplug before cleaning.
• Wipe with soft semi-dry cloth. Don't use chemical agents, such as benzene, alcohol and gasoline etc; otherwise surface
of the A/C and potentially the whole A/C will be damaged.
• Prevent water from spilling into the A/C.
FILTER
• Wash the fi lter once every two weeks. If it is blocked by dust, effi ciency of the A/C will be reduced.
• Pull out the big and small fi lters as shown in the picture below.
• Put the fi lters into warm water (about 40°C / 104°F) with neutral detergent added to it. Dry it in a shady place after
cleaning.
SEASONAL
CLEANING
If the A/C will not be used for a long time:
• Pull out the water plug to drain.
• Run the A/C under fan mode for 2 hours until the inside is dry.
• Turn off the A/C and unplug.
• Wash the fi lters and reassemble them.
• Remove the exhaust pipe.
• Cover the A/C and exhaust pipe with a plastic bag and store it in a dry place.
INTELLIGENT ERROR
DETECTION
Error-detecting code
E1
E2
E3

CARE AND MAINTENANCE

Error with the coils temperature sensor.
Error with the indoor temperature sensor.
Anti-freeze protection: Temperature of the coil is too low and the A/C is off. When
temperature increases to 8°C (46.4°F), the protection is released and previous
setting is recovered.
Multi-functional defection
8