Basic Function - LENCO MC-030 Mode D'emploi

BASIC FUNCTION

When the unit is in standby press the "
on press the Source button on device or remote to switch between your sources. Long pressing the "
will turn off the unit.
CLOCK
NOTE: You can only set the clock when device is in standby!
1. Press "Clock" button and "12H/24H" will flash on display.
2. Press " /
3. Press "Clock" button to confirm
4. Press " /
5. Press "Clock" button to confirm
You can also short-press the clock button on RC while playing any source to see the time for a short moment.
EQUALIZER
There are some pre-set equalizer options: Rock, Jazz, Pop, Classic, Normal. The default setting is set to normal.
To change the equalizer setting, you have to press and hold the MODE/EQ button on the device for 2 seconds or short-
press the EQ button on the remote control. Repeat this until you reach the equalizer setting you want.
SLEEP (timer)
There is a sleep timer function on the device. To use this function hold the
SLEEP button on the RC.
- Long press on the unit or short press this button on the RC, the display will show "90". This means that after 90
minutes the device will go into stand-by
- Long press on the unit or short press this button on the RC again to decrease the time
- Repeat the above procedure to choose the desired time.
SOURCE: RADIO
AUTOMATIC/MANUAL TUNING
1. Press the " /Source" button on the device or the radio button on the RC to select Radio mode.
2. Press and hold "
3. When a station is tuned in the tuning process, it will automatically Pre-set to station list.
4. Short-press "
PRESET
1. Short-press the "MODE" button to start the preset process.
2. Display will show "P01" and flashing.
3. Use " /
/Source" or
" button to select "12H or 24H" time format
" button to select "Hour and Minute"
/SCAN" Button 2 seconds to start automatic tuning process.
/ " buttons to manually change the frequency by a fixed step (0,05MHz).
" to determine the preset station number.
button on the remote control to turn on the. When the unit is
button on the device or short-press the
8
/Source" button