Watts Dormont SmartSense V1-TS Instructions D'installation page 10

4. It is recommended that leak testing is done using non-corrosive gas leak detection fluid (such as Big Bubble gas leak
detector by JC Whitlam Mfg., Snoop liquid leak detector by Nupro Co., or Leak-Tech gas refrigerant leak detector by
Federal Process Corporation). Dish washing detergent, bath soap or other household chemicals should not be used.
! WARNING
DO NOT USE matches, candles or any open flame to leak test gas connections.
DO NOT USE electrical equipment such as a fan to dissipate gas vapors as electric motors can spark and ignite gas
vapors causing fire or explosion which may result in property damage and/or personal injury including death.
DO NOT dilute leak test solution.
5. Apply enough solution to each threaded joint (including the connector) so that it covers the entire circumference of
the joint. Hold a towel or rag under joints to catch any spill-over.
6. If there are any leaks, bubbling will appear at the joint(s). Use a small mirror to view obscured areas.
• If a leak is detected, tighten the connection and retest.
• If the leak is not remedied by tightening or the odor of gas is detected, TURN OFF GAS VALVE to the appliance and
have a licensed plumber correct the problem.
7. After testing, thoroughly rinse all joints with water and dry.
! WARNING
DO NOT turn on any appliance until all connections are leak tested.
8. After leak testing your installation, follow your appliance manufacturer's instructions to turn on your appliance and
ensure it is operating correctly.
!
If you are not sure how to turn on the appliance and ensure it is operating correctly, turn off the gas
at the shut-off valve and call a licensed plumber or qualified service technician to check the appli-
ance operation and fix any problems.