Residual Hazards, Layout Of Safety Instructions - Lenze starttec Instructions De Montage

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Show/Hide Bookmarks
Safety instructions
1

Residual hazards, layout of safety instructions

Residual hazards
Protection of
Disconnect the starttec before you start working on the device or opening it because the
l
persons
power connections L1, L2, L3, 1U, 1V, 1W, 2U, 2V, 2W, B1, B2 and BN carry dangerous
voltage:
– After you have opened the startec check whether the power connections L1, L2, L3, 1U,
1V, 1W, 2U, 2V, 2W, B1, B2 and BN are dead.
– Even if the starttec is inhibited (terminal 28 = LOW), the connections 1V, 2V, B1 and B2
carry dangerous voltage!
Shut down:
l
– External influences - e. g. overvoltage through lightning strike - may damage the starttec
with the consequence that the motor continues to run on two phases although the
starttec is inhibited (terminal 28 = LOW).
– If necessary, additional protective measures must be taken (e. g. extra separation of the
mains), dependent on the risk analysis of the machine/plant.
The metal housing of the starttec reaches an operating temperature of > 60 °C:
l
– Direct skin contact with the metal housing can lead to burns.
Device
Certain starttec settings can overheat the connected motor:
l
protection
– No PTC thermistor or thermostat (NC contact) connected to the motor and temperature
monitoring not configured (C0119).
– Rated motor current not adapted to motor (C0120).
2
– I
t monitoring not active, no activation class set (C0121).
Layout of safety instructions
All safety instructions given in this documentation have the same layout:
Signal word
Text (describes the danger and informs about ways to avoid it)
Pictograms used
Warning of
damage to
persons
Warning of
damage to
material
Other notes
10
(indicates the degree of danger)
Signal words
Warning of
Danger!
dangerous
electrical
voltage
Warning! Warns of possible and very dangerous
Warning of
general
danger
Caution!
Stop!
Note!
EDK71MMXXX-020 DE/EN/FR 1.0
Warns of impending danger .
If disregarded:
Death or most severe injuries
situations .
If disregarded:
Death or most severe injuries
Warns of possible and dangerous situations .
If disregarded:
Minor injuries
Warns of possible damage to material .
If disregarded:
Damage of the controller/drive system or its
environment
Indicates a useful tip.
If you follow this tip, handling of the
controller/drive system will be easier.
L

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

2

Table des Matières