Natural Mode (In Tile Mode) (Command : D J); Dpm Select (Command: F J); Temperature Value (Command: D N) - HP Touch Screen Guide De L'utilisateur

*Set Tile V Position to 0x00 before setting Tile V Size.
* This function is available only when the Natural option of the Tile Mode is set to Off while the Tile
Mode set to On.
Transmission
[d][h][ ][Set ID][ ][Data][Cr]
Data
00 to 50 (00H to 32h)
** It may not be supported depending on the model.
Acknowledgement
[h][ ][Set ID][ ][OK/NG][Data][x]

32. Natural Mode (In Tile Mode) (Command : d j)

To display the image naturally, the part of the image that would normally be displayed in the gap
between the displays is omitted.
Transmission
[d][j][ ][Set ID][ ][Data][Cr]
Data
00: Off
01: On
Acknowledgement
[j][ ][Set ID][ ][OK/NG][Data][x]

33. DPM Select (Command: f j)

To set the DPM (Display Power Management) function.
Transmission
[f][j][ ][Set ID][ ][Data][Cr]
Data
00: Off
01: On
Acknowledgement
[j][ ][Set ID][ ][OK/NG][Data][x]

34. Temperature Value (Command: d n)

To check the inside temperature value.
Transmission
[d][n][ ][Set ID][ ][Data][Cr]
Data
Transmission / Receiving protocol 101