Logo - La Cimbali M100 GT Utilisation Et Installation

21. Logo

The Cimbali standard logos are shown on all the machine
displays, after a period of inactivity set for the "Screensaver"
menu by the technician.
Technical staff can activate the parameter that allows to show on the services display or even on the groups display a
further logo customized by the user.
The machine is supplied with the logo shown in the image.
The user can replace it with another of the same size that will will appear on all displays (groups and
services), creating the le custlogo.bmp (maximum size 270 x 170 pixels).
Alternatively, the user can realize a larger image for the groups display ( le logogrp.bmp - 272 x
480 pixels) and one for the services display ( le logosrv.bmp - 270 x 170 pixels).
To create a customised logo, proceed as follows:
1
Using any graphics program (e.g. Paint),
create a le that meets certain characteristics
the prerequisites for a bitmap image to be
used as a custom logo are:
custlogo.bmp
logosrv.bmp
• width less than • width less than
or equal to 270 or equal to 272
pixels pixels
• length less than • length less than
or equal to 170 or equal to 480
pixels. pixels.
• 2 4 - b i t b m p • 2 4 - b i t
colour. colour.
Copy into a USB pen drive les "logogrp.
bmp" and / or "logosrv.bmp" if the user
wants to display a logo for the groups
display and one for the services display.
Copy the le "custlogo.bmp" if the user
wants to display the same logo on all
displays.
NOTE: If in the USB pen drive there are all
les logo, will be displayed the image of the
le "custlogo.bmp".
4
Press OK and wait for the le to load:
2
Insert the USB pen drive in the
dedicated slot on the machine:
logogrp.bmp
b m p
3
Turn the machine off and back on again when it comes back on the following
will appear on the services display:
If in the USB pen drive there is the
le logogrp.bmp and / or logosrv.
bmp
5
Once loading is complete, remove the USB pen drive from the machine.
At this point, the custom logo will be displayed according to the settings
programmed by the technical staff.
Note: If the screensaver is active, it is possible immediately see the logos, without
waiting for idle time, every time the user turns off the analogically gauge.
the
services display:
27 EN
icon will appear on the
If in the USB pen drive there is the
le custlogo.bmp