Ductwork Installation; Wiring To Power Supply; Accessories; Final Assembly - KOBE CH9130SQB Manuel D'installation Et Mode D'emploi

Ductwork Installation

5. Use aluminum or steel pipe to connect the
6" round plastic exhaust on the hood to
the ductwork above.
make all joints secure and air tight. Refer
to Figure 4.
To convert ductwork to 7" round, attached
6.
7" round adapter (provided) to the 6"
round plastic exhaust.

Wiring to Power Supply

SAFETY WARNING
RISK OF ELECTRICAL SHOCK.
RANGE HOOD MUST
GROUNDED. MAKE SURE THIS IS DONE
BY SPECIALIZED
ACCORDANCE WITH
NATIONAL AND
CODES. BEFORE CONNECTING WIRES,
SWITCH POWER OFF AT SERVICE PANEL
AND LOCK SERVICE PANEL TO PREVENT
POWER FROM BEING
ACCIDENTALLY.
7. Connect the electrical wires.
-
Connect three wires (black, white and
green) to house wires and cap with wire
connectors. Connect according to color:
black to black, white to white, and green
to green as shown on Figure 5.
-
If necessary to hide the electrical wire
connections, push wires back into the
wiring box. Access the wire connections
underneath the hood. Make sure wires
do not slip between motor or any
moving parts to prevent any damage.

Accessories

8. Attach oil tunnel. Refer to Figure 6.
Refer to Figure 7.  Slide the baffle filter
9.
into the hood.
 Slide forward.
upward.
downward.  Fit into place.
10. For bottom casing, repeat above steps.
Refer to page 16.

Final Assembly

11. Turn power ON in control panel. Check
all lights and fan operation.
12. Make sure to leave this manual for the
homeowner.
Use duct tape to
THIS
BE PROPERLY
ELECTRICIAN
ALL APPLICABLE
LOCAL ELECTRICAL
SWITCHED
 Push the baffle filter
 Pull
Figure 5
Figure 6
IN
ON
Figure 7
9