Periodic Maintenance - IARP MIRA 23 N FLAT Instructions D'emploi Et D'entretien

PERIODIC MAINTENANCE

WARNING! ANY WORK CARRIED OUT
ON THE APPLIANCE BY THE USER
STRICTLY REQUIRES THE POWER
PLUG BEING DISCONNECTED FROM
THE MAINS SOCKET.
Inspect the power cable to see if it is damaged.
If the power cable is damaged, do not use the
appliance and try to repair it: it must be replaced by the
manufacturer or its customer service department or by a
similarly qualified person, in order to prevent any risks.
No protection (grill or guard) should be removed by
unqualified personnel and strictly avoid operating the
appliance with these protections removed.
The replacement of lamps must be carried out only by
an Authorized Service Center.
The lamps have to be replaced by identical lamps only.
For a good preservation of the cabinet's body a periodical cleaning is necessary.
EXTERNAL BODY: When necessary, the external body should be cleaned with a cloth and a neutral
soap and water solution.
STAINLESS STEEL SURFACES: Wash with warm water and mild detergent, rinse well and dry
with soft cloth. Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL: Wash with warm water and mild detergent, rinse well and
dry with soft cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES: Only use products specifically designed for glass cleaning; It is not advisable
to use ordinary water which can leave a film of calcium on the surface of the glass.
DEFROSTING AND TANK CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING
THE POWER PLUG BEFORE CLEANING.
If , however, the layer of frost on tank walls exceeds 4/5 mm in thickness, you should completely
defreeze the appliance as follows:
1. Place the goods in special refrigerated containers, kept at the same temperature and remove the shelves
2. Unplug the unit
3. Leave the doors open and begin the operation of tank washing when the tank temperature is
the same as the ambient temperature.
4. Clean and dry the interior of the tank with a soft cloth, using neutral soap.
5. Then plug the unit and wait till the appliance reaches the right temperature before filling it again.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the cabinet.
Warning! Do not use water jets for cleaning: this can damage the electrical
parts.
Warning! Do not use mechanical appliances or other means to speed up the
defrosting process, other than those recommended by the manufacturer.
Unplug
the unit
-19-