Woodstar wl 05 Traduction Du Manuel D'utilisation Original page 26

problem
Motor doesn't start
Work piece flatters
while working
Tool rest or tailstock
cannot be clamped
26
Trouble shooting
possible Cause
a) No electricity
b) Defective switch, condenser
c) Defective extension cord
a) Working piece becomes loose
while working
b) Work piece is not properly centered
c) Rotational speed is too high
Setting the eccentric clamping
help
a) Check fuse
b) Have an electrician inspect unit
c) Unplug cord, inspect and replace, if nec-
essary
a) Follow the instructions in the operating
manual
b) Follow the instructions in the operating
manual
c) Select a lower rotational speed
Return the hexagonal nut at the bottom side
about ½ rotation with the socket spanner