Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fig. 5
22
IMpORTANT REMARK:
The motor is automatically switched off in the event of
an overload. The motor can be switched on again after a
cooling down period that can vary.
DEFECTIVE ELECTRICAL CONNECTION CABLES
Electrical connection cables often suffer insulation dam-
age.
Possible causes are:
•
Pinch points when connection cables are run through
window or door gaps.
•
Kinks resulting from incorrect attachment or laying of
the connection cable.
•
Cuts resulting from running over the connecting ca-
ble.
•
Insulation damage resulting from forcefully pulling out
of the wall socket.
•
Cracks through aging of insulation.
Such defective electrical connection cables must not be
used as the insulation damage makes them extremely
hazardous.
Check electrical connection cables regularly for damage.
Make sure the cable is disconnected from the mains
when checking.
Electrical connection cables must comply with the regu-
lations applicable in your country.
SINGLE-phASE MOTOR
•
The mains voltage must coincide with the voltage
specified on the motor's rating plate.
•
Extension cables up to a length of 25 m must have a
cross-section of 1.5 mm2, and beyond 25 m at least
2.5 mm2.
•
The connection to the mains must be protected with a
16 A slow-acting fuse.
Only a qualified electrician is permitted to connect the
machine and complete repairs on its electrical equip-
ment.
In the event of enquiries please specify the following
data:
•
Motor manufacturer
•
Type of current of the motor
•
Data recorded on the machine's rating plate
•
Data recorded on the switch's rating plate
If a motor has to be returned, it must always be dis-
patched with the complete driving unit and switch.
Maintenance
•
Overhauls, maintenance work, cleaning, as well as the
elimination of any malfunctions must only be under-
taken after turning off the motor.
•
All protective and safety equipment must be rein-
Publicité
Table des Matières
