Makita DGA419 Manuel D'instruction page 10

Installing or removing wheel guard
WARNING:
When using a depressed center
wheel, the wheel guard must be fitted on the tool
so that the closed side of the guard always points
toward the operator.
WARNING:
When using an abrasive cut-off /
diamond wheel, be sure to use only the special wheel
guard designed for use with cut-off wheels.
For depressed center wheel, abrasive
cut-off wheel, diamond wheel
While pushing the lock lever, mount the wheel guard
with the protrusions on the wheel guard aligned with the
notches on the bearing box, and then rotate the wheel
guard until the wheel guard is locked in place.
1
► 1. Lock lever 2. Notch 3. Protrusion
To remove wheel guard, follow the installation proce-
dure in reverse.
When using a depressed center
wheel
Optional accessory
WARNING:
wheel, the wheel guard must be fitted on the tool
so that the closed side of the guard always points
toward the operator.
► 1. Depressed center wheel 2. Wheel guard
When using an abrasive cut-off /
diamond wheel
3
Optional accessory
WARNING:
2
diamond wheel, be sure to use only the special wheel
guard designed for use with cut-off wheels.
WARNING:
grinding.
► 1. Abrasive cut-off wheel / diamond wheel 2. Wheel
guard for abrasive cut-off wheel / diamond wheel
10 ENGLISH
When using a depressed center
1
2
When using an abrasive cut-off /
NEVER use cut-off wheel for side
1
2